It works.Īnd if you look at the status, of course, in Proficy, nothing’s changed, it’s all the same, it hasn’t lost connection. Port 2 is blinking, that tells me that responding. Immediately I have a connection, I have communication. I’m going to plug it into the RS85 port, and Now that it’s in run mode, I want to test the two ports: port 1 and port 2 on the CPU itself.

OK, and of course, if you look in the Proficy, you’ll see your status has been moved to run mode. We’re going to turn this key to the on mode or run mode, and now work in run mode. On or off is referring to the memory protection. I do this because it has two features: one is run or stop the other one is on or off. You’ll see the parameter ‘Key Switch Run/Stop’ has been ‘enabled’. If you right click on the CPU on the right hand side, and look at the configuration on the left. This may be due to our Run/Stop switch position, Application.’ However, if you look down below in the ‘feedback zone’, you’re going to see ‘The Controller is not in Run Mode after you attempted to start it. We’re going to try to test all aspects of the CPU first is getting into run mode for it to test the other ports, switches.Īnd we’re going to hit OK to get into run mode. This is just a simple test to see if the device works. We don’t want to download anything else we don’t want to download to the flash memory. The first thing it’s going to ask is what you want to download?įor this test, we want to download ‘Hardware Configuration and Motion’ and ‘Logic’ Now that the faults are clear we are going to download and run. Clearing the memory here could affect the performance of your CPU. Don’t clear all memory, or other memory options. Moving forward, we want to clear any controller faults and IO faults. And now that it’s in programmer mode, I’m going to go to ‘Target’ menu item and then go to ‘Clear’ menu item.

Ge 90 30 plc software